Plastic material
The plastic material machine is mostly produced in two different forms, each of which has its own characteristics and functions. These models are classified into two air and ground categories according to the location where the funnel and suction motor are located, and the characteristics of each have been explained.
🟠 Aerial plastic materials
In this type of device, the hopper and the suction motor are connected to each other. This material is placed on the material feeder and the raw material is pumped to the plastic injection machine. This model has a smaller size than the ground type and has a lower power consumption and it is used in lighter jobs. This model is used when the material tank is near the plastic injection machine.
🟠 Ground plastic material material
In this model, the hopper and motor are not connected to each other and are separate from each other. The motor of this device is placed on the ground and is completely fixed, but the funnel is placed on the top and the suction is done by the motor and the materials are pumped out of the funnel. And it is necessary to use the ground type. It is obvious that the larger the plastic material injection machine has larger dimensions and also the larger the volume of plastic material consumed per hour, the need for a larger material removal machine.
Component
